If you have a EVM-HD-8FXS/DID with faxes connected via a breakout panel in one building, and a fibre connection to another building where additional fax machines are located how do you connect them ? Is the ATA the only way to go ? due to the electrical grounding difference ?
I do not know what your are refering to as far as the ground issue but no you cannot extend the FXS ports over fiber they would require a copper pair back to the router that has the module in it. ATA would probably be your best bet.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...