Ok, then can you help in how to configure the dial-peers on the router to send DID (DTMF) for a FAX call the FaxPress will recognize and process? The FaxPress 2500 is a 2 port analog model from their website.
As far as I can tell, once the FXS port goes offhook no more digits are sent. Right now the FaxPress gets a FAX but can't route it to the DID (individual mailbox) since no digits are being sent.
I only have access to the router, someone else is doing the FaxPress side which I have not worked with before. They tell me the FAX ends up in the unaddressed mailbox or something.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...