We are having an issue with wireless phones 7921 and 7925 causing feedback when we perform paging. I am assuming that the cause of the feedback is because the mouthpiece on the wireless phones is too sensitive and is hearing the output over the paging speakers, thus causing a feedback loop.
My question is, do you know of any settings either on the phone or on the network equipment that would address this issue? Maybe something that causes the mouthpiece to be less sensitive?
There is no setting on the 792x phones and the FXS/FXO port you have is already doing the maximum 128ms of echo coverage that it can. You'll need to use a non-live recording mechanism. If you have a paging server from Syn-Apps or SingleWire they can support this natively. If not, you can try this Bogen module:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...