Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Finding out status of upgrade via CLI

Hello there!

We are upgrading our Call Manager to 6.1.3-3000 today, and during the upgrade the status went from 'Running' to 'The application has lost communication with the system. Check the status using CLI.'

The install log still updates every few minutes, but it is still reassuring to know when the install is done.

Has anyone else encountered this before, or knows how to resolve it?

Thanks!

4 REPLIES

Re: Finding out status of upgrade via CLI

Hello Jonathan,

What you could do is log back into OS administration GUI, go into Install/TFTP. There will be a Assume control button. You could click on it and see where you are at.

Thanks,

G

Please rate useful posts.
New Member

Re: Finding out status of upgrade via CLI

Hi everyone,

This is what I got back from TAC:

There are two ways to check the status:

Option 1: Through web browser:

1) Close all web browser windows and open a new one.

2) Go to CUCM OS Admin page > Software Upgrade > Install/Upgrade

3) The system will tell you that there's an upgrade in progress and would you like to assume control.

4) Say 'Yes' to assume control and you'll see the status.

Option 2: Through command line

Go to CUCM command line interface and type the command "utils system upgrade status"

So....thank you Michael!

New Member

Re: Finding out status of upgrade via CLI

I know this is an old thread but...

Thanks for posting TAC reponse. I can confirm that both of these status methods are still working on version 7.1

I think what causes the issue is the session times out while waiting for status updates. Since you're not clicking anything to keep the session active... Either way log back in goto install update and assume control and you're right back there... Or use cli but info there is limited.

New Member

Finding out status of upgrade via CLI

Very old post, but anyone coming here still may like an update. i'm doing an upgrade for call manager 8.6.2, and this process still works for assuming control, should you get this error during an upgrade.

7722
Views
25
Helpful
4
Replies