Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Firmware phone in CME.

f

Good morning team,

I have a qauestion, I am upgrade a phone (SPA5044G)  in CME (UC560-FXO-K9),

I  configure the next.

tft-server flash:namefimware alias nuevofirmware

telephonyy-server

load 504  nuevofirmware

ephone 20 pd

resent

end

I think the upgrade working properly, but i dont know if any comand for see the  firmware in use for the phone ?

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Firmware phone in CME.

Jorge,

You can run the command "show ephone phone-load"

That will show you the firmware version of each phone registered to CME based on Mac-address.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

3 REPLIES
Cisco Employee

Firmware phone in CME.

Jorge,

You can run the command "show ephone phone-load"

That will show you the firmware version of each phone registered to CME based on Mac-address.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

New Member

Firmware phone in CME.

Luis,

Thanks for you help,  excelent reply.

I also use show cdp entry * version in my switch,  but it only use if the pone use cdp rigth, show ephone phone-load

can i use with other phone ?

regards

Jorge Cinco

Cisco Employee

Firmware phone in CME.

Just like you said, show dsp neigbors detail will show you good ingormation about the phone, but the swith and the phone need to support CDP protocol.

The show ephone phone-load will show you the firmware for every registered phone.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

1450
Views
2
Helpful
3
Replies
CreatePlease to create content