Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

force remote ip phone to use G.729

Dears,

Is there anyway to force a remote ip phone registered to cme to use codec g729 when it contacts local ip phones, unity express and pstn numbers?

Does the transcoder config on the cme and the g729 configuration on the remote ephone help?

Your help will be really appreciated

Best regards

1 REPLY
Bronze

Re: force remote ip phone to use G.729

Try putting this command under the ephone configuration:

codec g729r8 dspfarm-assist

Please rate if it helps. Thanks.

345
Views
0
Helpful
1
Replies
CreatePlease to create content