Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

force SABME message

I had a problem yesterday where the other end wouldn't send a UAf message in response to my SABMEp message as described here: http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00801509d7.shtml#topic2.

I have made some changes and would like to test it. Is it sufficient to do a shut/no shut on interface serial 2:23 to force each side to re-initialize?

1 REPLY

Re: force SABME message

Unfortunately this sounds like a Q.921 problem, and there aren't an abundant amount of ways to troubleshoot it.

The first thing you can try doing is removing MGCP configuration because Q.921 becomes tied into CUCM registration, and makes the entire thing very complex.

If you're having the issue with H323/SIP, it means there is a bonafide circuit problem. If it doesn't happen with H323, you will want to try restarting the CCM service, resetting the gateway in CUCM, removing the 'isdn bind-l3 ccm' command, or doing a 'no mgcp' 'mgcp' on the gateway. You're seeing erratic behavior most likely associated with a bug or flaky CUCM registration.

hth,

nick

259
Views
0
Helpful
1
Replies
CreatePlease login to create content