I have a voice gateway with a voice T1 circuit from a provider. I use dial peers to forward numbers to the call manager. I try to forward a specific number to a CTI route point but there is just silence on the line. It works if i use the operator hunt pilot number
Can you dial the CTI RP internally? Check the codec being used. Default for a voip dial peer is g.729. Make sure that the dial peer and the terminating device are using the same codec or you have a transcoder in place to handle the conversion.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...