Hi, i have a remote office where there are 30 Phones in the Lan, also the wan router has a VIC-2FXO with two lines connected to the PSTN. When there is an incoming call by any of the two lines, this is forwarded to an Extension (connection plar XXXX). I would want to know if there is a way to make that this call could be forwarded to more than one extension simultaniusly. I have a 3.3(5) Callmanager Cluster.
A nice simple way with CCM 3.3.5 would be to add this required extension on Multiple Phones as "Shared Lines". I am pretty sure that the ability to use the Broadcast Hunt Method was not added until CCM 4.0 :(
If the connection plar XXXX is where XXXX=4444 just add an apprearance of 4444 on the necessary phones and you are good to go!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...