I have a remote site with a 2811 with FXO ports. One if the FXO ports is set with PLAR to go to a single phone. That phone is set to forward on a no answer to a cell phone.
The user complains about low volume when calls are forwarded. It is my understanding that our system is no longer involved in the call after the froward, and that this is beyond our control. Is this correct?
Call comes in to 2811, CCM sets up call and then forwards out 2811 to cell phone - after setup our system drops out.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...