Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Fractional PRI

On what protocol can fractional PRI be configured, H.323 or MGCP? Think it's H.323 but not sure.

5 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Super Bronze

Re: Fractional PRI

I have used fractional PRi on MGCP. People say its not supported, but I think it is. Because I have used it before. To be safe stay with H.323

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
VIP Super Bronze

Re: Fractional PRI

Hall of Fame Super Red

Re: Fractional PRI

Hi Ashok,

Note: Cisco CallManager does not support the configuration or use of a fractional PRI when you use it with MGCP. If fractional PRI is necessary you can use H.323 instead of MGCP.

How to Configure MGCP with Digital PRI and Cisco CallManager

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

MGCP and H.323 Voice Gateway Protocol Comparison

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00806fedbe.shtml

The workaround for using a Fractional PRI with MGCP was perfectly detailed recently by Paul from Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc17407/0#selected_message

Hope this helps!

Rob

Silver

Re: Fractional PRI

MGCP Config:

controller E1 0/0/0

pri-group timeslots 1-31 service mgcp

description ***PRI***

!

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

!

ccm-manager fallback-mgcp

ccm-manager redundant-host x.x.x.x

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server x.x.x.x x.x.x.x

ccm-manager config

!

mgcp

mgcp call-agent x.x.x.x 2427 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp package-capability rtp-package

no mgcp package-capability res-package

mgcp package-capability sst-package

no mgcp package-capability fxr-package

mgcp package-capability pre-package

no mgcp timer receive-rtcp

mgcp sdp simple

mgcp rtp payload-type g726r16 static

mgcp bind control source-interface GigabitEthernet0/0

mgcp bind media source-interface GigabitEthernet0/0

Silver

Re: Fractional PRI

H.323 Config (for BRI in the UK)

isdn switch-type basic-net3

!

voice-card 0

no dspfarm

dsp services dspfarm

!

voice call send-alert

voice rtp send-recv

!

voice service voip

h323

modem passthrough nse codec g711ulaw

!

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8 bytes 40

!

voice class h323 1

h225 timeout tcp establish 3

!

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn twait-disable

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

!

voice-port 0/0/0

translation-profile incoming incoming

compand-type a-law

cptone GB

!

dial-peer voice 1 pots

tone ringback alert-no-PI

preference 1

destination-pattern 9T

progress_ind setup enable 3

progress_ind progress enable 8

incoming called-number .

direct-inward-dial

port 0/0/0

!

dial-peer voice 999 pots

tone ringback alert-no-PI

preference 1

destination-pattern 999

progress_ind setup enable 3

progress_ind progress enable 8

port 0/0/0

forward-digits all

!

dial-peer voice 5000 voip

destination-pattern 5...

progress_ind setup enable 3

no modem passthrough

voice-class codec 1

voice-class h323 1

session target ipv4:X.X.X.X

dtmf-relay h245-alphanumeric

fax rate 7200 bytes 48

fax nsf 000000

fax protocol pass-through g711ulaw

no vad

16 REPLIES
VIP Super Bronze

Re: Fractional PRI

I have used fractional PRi on MGCP. People say its not supported, but I think it is. Because I have used it before. To be safe stay with H.323

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: Fractional PRI

Deji,

Need one more favour. Could you please give me the sample configs for each protocol?

Regards,

Ashok.

VIP Super Bronze

Re: Fractional PRI

New Member

Re: Fractional PRI

Deji you simply rock! Just one more favour here - I see there are 2 options of configuring MGCP - Automatic, where the config gets downloaded from CCM & manual. Is there any particular reason for using any particular method?

Regards,

Ashok.

VIP Super Bronze

Re: Fractional PRI

Using the CCM-Config command makes configuration easier..Some pople like it, some dont. I dont like it because sometimes it can give you problems.

Baiscally, the ccm-config methos configures the oruter automatically, and the manual one is manual

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: Fractional PRI

Thanks again Deji for all the time you took out today to answer all my queries. Happy weekend!!

Regards,

Ashok.

New Member

Re: Fractional PRI

Deji,

Need one more favour. Could you please give me the sample configs for each protocol?

Regards,

Ashok.

Silver

Re: Fractional PRI

MGCP Config:

controller E1 0/0/0

pri-group timeslots 1-31 service mgcp

description ***PRI***

!

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

!

ccm-manager fallback-mgcp

ccm-manager redundant-host x.x.x.x

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server x.x.x.x x.x.x.x

ccm-manager config

!

mgcp

mgcp call-agent x.x.x.x 2427 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp package-capability rtp-package

no mgcp package-capability res-package

mgcp package-capability sst-package

no mgcp package-capability fxr-package

mgcp package-capability pre-package

no mgcp timer receive-rtcp

mgcp sdp simple

mgcp rtp payload-type g726r16 static

mgcp bind control source-interface GigabitEthernet0/0

mgcp bind media source-interface GigabitEthernet0/0

Silver

Re: Fractional PRI

H.323 Config (for BRI in the UK)

isdn switch-type basic-net3

!

voice-card 0

no dspfarm

dsp services dspfarm

!

voice call send-alert

voice rtp send-recv

!

voice service voip

h323

modem passthrough nse codec g711ulaw

!

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8 bytes 40

!

voice class h323 1

h225 timeout tcp establish 3

!

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn twait-disable

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

isdn static-tei 0

!

voice-port 0/0/0

translation-profile incoming incoming

compand-type a-law

cptone GB

!

dial-peer voice 1 pots

tone ringback alert-no-PI

preference 1

destination-pattern 9T

progress_ind setup enable 3

progress_ind progress enable 8

incoming called-number .

direct-inward-dial

port 0/0/0

!

dial-peer voice 999 pots

tone ringback alert-no-PI

preference 1

destination-pattern 999

progress_ind setup enable 3

progress_ind progress enable 8

port 0/0/0

forward-digits all

!

dial-peer voice 5000 voip

destination-pattern 5...

progress_ind setup enable 3

no modem passthrough

voice-class codec 1

voice-class h323 1

session target ipv4:X.X.X.X

dtmf-relay h245-alphanumeric

fax rate 7200 bytes 48

fax nsf 000000

fax protocol pass-through g711ulaw

no vad

New Member

Re: Fractional PRI

Thanks Darren for all the effort you took to help me out.

Regards,

Ashok.

Hall of Fame Super Red

Re: Fractional PRI

Hi Ashok,

Note: Cisco CallManager does not support the configuration or use of a fractional PRI when you use it with MGCP. If fractional PRI is necessary you can use H.323 instead of MGCP.

How to Configure MGCP with Digital PRI and Cisco CallManager

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

MGCP and H.323 Voice Gateway Protocol Comparison

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00806fedbe.shtml

The workaround for using a Fractional PRI with MGCP was perfectly detailed recently by Paul from Cisco;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc17407/0#selected_message

Hope this helps!

Rob

Silver

Re: Fractional PRI

Fractional E1 may not be supported with MGCP but its certainly configurable. Register your Voice Gateway with callmanager using the ccm-manager config command, but then remove this command and reconfigure the E1 as fractional. Works for me everytime.

New Member

Re: Fractional PRI

Thanks again Rob, happy weekend in advance - Ashok.

New Member

Re: Fractional PRI

Hi Rob,

Just curious here - is something similar ( Fractional PRI) possible with SIP gateways?

Regards,

Ashok.

Hall of Fame Super Red

Re: Fractional PRI

Hey Ashok,

First off you are most welcome :) Can't wait for the weekend, it can't come fast enough!

I am not very familiar with SIP :( I do know that this clip is very applicable;

Capacity scaling: IP traffic is not bound to strict timeslot capacity of TDM trunks. Thus it is easier to scale the call capacity of Unified Communications trunks. Moreover, bandwidth can be dynamically allocated based on the application mix, number of sessions, etc. for optimum performance of the currently active applications.

From these excellent White Papers;

http://www.cisco.com/en/US/products/sw/voicesw/ps5640/prod_white_papers_list.html

Hope this helps!

Rob

New Member

Re: Fractional PRI

Thanks again Rob.

Ashok.

335
Views
20
Helpful
16
Replies