I have a phone connected to 2-port FXS card on ISR 2821 router.this router is registered to CCM 6.0.I selected SCCP while adding this voice router to the CCM.
The problem is there is no dial-tone on the analogue phone connected to fxs port.Hence we can't make outgoing calls from analogue phone to otherIP Phones reg on ccm.But strangely incoming call to this phone from other IP phones reg to call mgr works fine.
The analogue phone is properly registered in the CCM.
Attached is the configuration of the ISR router.
Can somebody suggest if something is to be more configured on 2811 or in the CCM.
atatched is the ISR router config.
If necessary please suggest appropriate URL to look into.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...