Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FX0 csim question.

I currently have several 2821 routers located across multiple sites. The routers are only used for outbound 911 calls. They have 2 analog phone lines attached to a 4 port FX0 card.  I have been using the csim command to remotely test to make sure the lines are up and functioning. Is there a way to take one of the ports of the FX0 card offline, so when I use the csim command to test, it will test the second line as well?

5 REPLIES
New Member

Re: FX0 csim question.

Just create a specific "test" pots dial peer with the destination-pattern and the FXO port that you want to test.

Once you test, you can either remove the "test" pots dial peer or just "shut" it until you want to test again.

Re: FX0 csim question.

I would guess you can just put that particular fxo port in shutdown.

New Member

Re: FX0 csim question.

I thought so to, but I am not sure how to shut those specific ports down.

Cisco Employee

Re: FX0 csim question.

use "shut" CLI under the concerned voice-port or dial-peer

to exclude it from being used in any call.

Bronze

Re: FX0 csim question.

After testing the first port, busy it out by going under the voice-port and entering the command "busyout force".

394
Views
0
Helpful
5
Replies
CreatePlease to create content