Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO/911 configuration?

We just installed a pots line at one of our remote site locations. We are trying to use a four port FXO card to configure the one pots line for 911 calls for this remote office. Our gateway protocol is MGCP. I am not sure how to configure the FXO port access from the gateway (cisco 2811). Can someone who has done this before please advise. Thank you.

Rgds,

Vicky

4 REPLIES
New Member

Re: FXO/911 configuration?

I will take a stab at this one...... :)

If you already have the MGCP gateway registered and working the key for the FXO ports is:

dial-peer voice XXX pots

service mgcpapp

port XXX (fxo port)

That should do it and it should become available for you to configure. Then you can place the port in a route group and then route list and ultimately the route pattern for 911. I set this up in our SF office and it works.

New Member

Re: FXO/911 configuration?

i can grab some official Docs from the GWGK book....1 sec

New Member

Re: FXO/911 configuration?

Thank you so much for your help here. We got the MGCP gateway to tie out to the gateway but we got a "rejected" on the fxo registration. It looks like we need to add one dsp to the gateway to make this work. ARRRRGGGHHH!!!

Anyway, thank you for your response here. Much obliged.

Rgds,

Vicky

New Member

Re: FXO/911 configuration?

well congrats on figuring it out....I know how frustrating this stuff can get.

275
Views
3
Helpful
4
Replies