Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXO and Caller ID

Hi all,

I have 3845 router added to CCM as H.323 gateway.

I am using this IOS : c3845-advipservicesk9-mz.124-3i.bin

and it contains 2 VIC2-4FXO cards.

I added the configuration :

caller-id enable

caller-id alerting ring " 2 and sometime 1"

I tried to change the cp tone and other parameters but no luck.

I used : debug vpm signal and I found:

get_fxo_caller_id:Caller ID receive failed.  parseCallerIDString:no data.

but when if I connect analog phone to the line directly I can find the caller ID.

one more thing: When I can use the command:

caller-id alerting dsp-pre-allocate

sometimes I am able to find the dsp-pre-allocate and sometimes no?

1 REPLY

Re: FXO and Caller ID

Hi,

Please search first on the space before posting.

Follow the steps:

     1. Connect an analog phone and confirm if your service provider is sending the caller-id,

     2. If they are sending properly this is most likely a well known bug if you are facing on H.323 mode, upgrade the IOS to any 12.4(20)T or higher.

This post might help you!

https://supportforums.cisco.com/message/1148237

HTH.

Please rate helpful posts!

255
Views
0
Helpful
1
Replies