Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

FXO and MGCP call disconnection delay pblm in saudi Arabia

voice experts in saudi arabia,

If u r facing any pblm like this please respond

1) PSTN user dials FXO port and call setup

2) hang-up the call by PSTN user

3) takes about 2 minutes to comes fxo to onhook

4 REPLIES

Re: FXO and MGCP call disconnection delay pblm in saudi Arabia

I tried:

1 change to diffrent IOS

2 no battery reversal and all

3 tried http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

4 dsp codec complexity to medium,flex

the show run,show voice port and debug outputs are attached herewith....

Voice experts please help...it is very urgent

Re: FXO and MGCP call disconnection delay pblm in saudi Arabia

If you make a call between an IP phone and the PSTN and hang up on the PSTN first, does the IP phone hear anything?

-nick

Re: FXO and MGCP call disconnection delay pblm in saudi Arabia

If a pstn caller makes a call and attended by the ip phone then disconnect by pstn ,it is working fine

But pstn caller disconnects before attending by an ipphone,then there is pblm with fxo port

One more thing : some of the calls are not attending by the router(there is a ring detection and suddenly disconnects)

Re: FXO and MGCP call disconnection delay pblm in saudi Arabia

I managed to find one solution...

voice class custom-cptone SaudiTelecom

dualtone disconnect

frequency 425

cadence 250 250

voice-port 0/0/1

supervisory disconnect dualtone mid-call

supervisory custom-cptone SaudiTelecom

battery-reversal detection-delay 10

cptone SA

timeouts call-disconnect 5

timeouts wait-release 5

timing hookflash-out 500

shut

no shut

539
Views
5
Helpful
4
Replies
CreatePlease to create content