Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO And Unity Voicemail - disconnect issue

I have a site where a standard POTS line is connected to a 2851 router FXO port. This is an MGCP gateway.

The problem I have is that when I call the number (10 digit) and leave a voice mail, about 10 seconds later the phone rings from an unknown number.

Troubleshooting steps taken:

1) I thought it may be an FXO disconnect problem. Changed port to ground start

2) Disabled supervisory disconnect

After attempting both of these, the issue is still happening. Any advice is greatly appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: FXO And Unity Voicemail - disconnect issue

3 REPLIES
Hall of Fame Super Gold

Re: FXO And Unity Voicemail - disconnect issue

Hi, unless telco changes to ground start too (that is used only in the US), that has no effect. So you will need to configure tone based disconnect supervision, there's is no alternative.

New Member

Re: FXO And Unity Voicemail - disconnect issue

I was afraid of that....best way to do tone based disconnect?

Hall of Fame Super Gold

Re: FXO And Unity Voicemail - disconnect issue

348
Views
3
Helpful
3
Replies