Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FXO CALL BLOCKING

In my network cisco ip phones are controlled by cme and there is 4 fxo ports and pri and in this fxo port have configured connection plar how to enable call blocking through this fxo because in currrent scenario user can make blocked calls through this fxo port

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hello,Try implementing the

Hello,


Try implementing the LPCOR to block calls. PFB some reference docs and you can find more on cisco/google

 

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/command/reference/cme_cr/cme_l1ht.html#wp1063898

 

https://supportforums.cisco.com/discussion/11411236/lpcor-fac-issue-voice-ports-cme85

 

Br,

Nadeem

Br, Nadeem Please rate all useful post.
5 REPLIES
Cisco Employee

Hello,Try implementing the

Hello,


Try implementing the LPCOR to block calls. PFB some reference docs and you can find more on cisco/google

 

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/command/reference/cme_cr/cme_l1ht.html#wp1063898

 

https://supportforums.cisco.com/discussion/11411236/lpcor-fac-issue-voice-ports-cme85

 

Br,

Nadeem

Br, Nadeem Please rate all useful post.
Cisco Employee

Hi,You can use COR lists to

Hi,

You can use COR lists to prevent the users on making unwanted calls.

In this case the ephone-dn will have the incoming COR lists assigned to them and the dial-peers for FXO and PRI will have outgoing COR list applied to it.

To make a successful call incoming COR list should be equal or superset of outgoing COR list.

Hence the dn's that should have access should have equal or superset and the dn's whom to block should have subset COR list .

You can learn how to configure below:

http://www.cisco.com/c/en/us/support/docs/voice/call-routing-dial-plans/42720-configuring-cor.html

Thanks

Divjot Nanda

 

**Please rate useful posts**

New Member

in telephony service i have

in telephony service i have used all hours block patterns but it is not getting applied am going through the documents

Cisco Employee

Hi,Kindly let us know what is

Hi,

Kindly let us know what is the exact requirement. are you looking for time based blocking or blocking PSTN calls to certain users.

Thanks

Divjot Nanda

 

**Plese rate useful posts**

New Member

Hi My requirement is that

Hi

 

My requirement is that want to block all users calling certain countries  and i did through time based blocking but it is not working while calling through FXO but working fine through PRI

 

83
Views
0
Helpful
5
Replies
CreatePlease to create content