FXO card installation on MGCP gateway and CUCM 8.5 cionfiguratio
Are you an administrator of the system? These are pretty trivial, yet assume some knowledge of the system, so perhaps you may want to hire a professional? However if you feel you can handle it, the high level steps are:
1. Configure the voice gateway with MGCP protocol
2. Build the Gateway in Communications Manager, define the port to point to internal extension via attendant field
3. Build a phone with that extension
Keep in mind an FXO port does not deliver DIDs, it is simply one number, just like a traditional home phone line.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...