we have cisco 2900 series H323 router with CUCM 7.1.5 in our office. Also we have 5 Analog CO Trunks which are terminated in FXO ports.
These 5 CO Trunks are used as backup incase the primary PRI failes. So that any ip phone can make/receive calls through this trunk. I have configured it. Can someone please check this and help how to configure properly. Im not receiving any calls through this FXO port.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.