Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO dial forwarding delay

We have 4FXO ports on 2811 and CM5.0...FXO ports are directly connected to TELCO. 2811 is a H323 gateway.

When someone calls from outside, he hears two rings. After that fxo forwards the call to an ip phone. It means ip phone rings n times, but caller hears the ring n+2 times. How can i solve this issue? I want the fxo port to forward the call immediately...But how?

voice-port 0/2/1

cptone GB

timing hookflash-out 50

connection plar 88(an ip phone)

2 REPLIES
Bronze

Re: FXO dial forwarding delay

Seems like FXO is looking for caller-id.

Check with the phonecompany if they are sending caller-id. If they are not sending caller-id removed the caller-id command from the voice-port.

New Member

Re: FXO dial forwarding delay

hi,

fxo port will wait for at least 1 ring to pickup the phone then plar to ur ip phone.

so in between the caller may wait for n+2 ring times.

you may check the command "ring number" , which defines the waiting time of a fxo port. and the default number is 1.

regards

steve

224
Views
0
Helpful
2
Replies