I have one CM in the main site and VG in the main site and the remote brance, CM version is 4.2, H323 is configured on the Main site VG and it is working fine. but in the remote site H323 is not working such that the call doesn't land on the operator phone while it is working fine using MGCP. when I do sho voice call status it shows "S_WAIT_RELEASE_NC".
the issue is not stuck ports, the issue is that I am not able to reveive the call on the operator phone from the VG, even if I try csim start 2701 (operator extension) the call fail. codec is g711ulaw and the operator phone and the VG are in the same device pool (same region).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.