03-14-2007 11:14 PM - edited 03-14-2019 08:29 PM
Hi,
I have implemented the following:
http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a008009431b.shtml
inter-branch calls work 100%. Problem is that when remote site phones out (PSTN breakout at HQ) the audio is extremely soft. Any ideas?
Thnx
Charl
03-15-2007 01:59 PM
Have you tried adjusting gains and attenuation under voice port ?
Also very important, check you optimal impedance setting:
http://www.cisco.com/en/US/tech/tk652/tk701/technologies_tech_note09186a0080477a06.shtml
Hope this helps, if so please rate post!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community