Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO issue

I have a customer who has a 2811 with two 4-port FXO modules. Some of these ports aren't disconnecting when you end a call. If you do a "show voice call summary" after you have disconnected the call, the voice port is still showing FXOLS_CONNECT under VPM state. Any ideas?

Below is the config for one of the voice ports that is having this issue:

trunk-group FXO

input gain -3

no comfort-noise

timeout interdigit 2

connection plar 34000

station-id number 34000

caller-id enable type 1

Thanks,

Chris

4 REPLIES
New Member

Re: FXO issue

An update:

The call does finally disconnect after several minutes.

Thanks,

Chris

Bronze

Re: FXO issue

Have posted a few times with my experience with this. my scenario was that calls would disconnect with time ranging from 13 secs to sometimes never.

had to create a voice class with tones specific values : cadence busy etc and also ask the provider to put the lines into a trunk group. purpose of this is to enable COD on their side.

this is what it looks like

voice class dualtone-detect-params 100

freq-max-deviation 50

freq-min-power 35

!

voice class custom-cptone TEST

dualtone busy

dualtone ringback

frequency 500 632

dualtone reorder

frequency 500 631

cadence 500 500

dualtone disconnect

frequency 630

cadence 500 500

and on the voice port

voice-port 0/0/0

supervisory disconnect dualtone mid-call

supervisory custom-cptone TEST

supervisory dualtone-detect-params 100

no battery-reversal

timeouts initial 4

timeouts interdigit 2

timeouts call-disconnect 0

connection plar 139

your values will probably not be the same. Also this by itself didnt work for me, i had to apply this as well as ensure the lines were in a trunk group with COD enabled.

P.S converting lines to Ground Start is also another solution.

New Member

Re: FXO issue

Hi,

try connection plar-opx xxxxx

New Member

Re: FXO issue

From what I understand, the connection plar-opx command cannot have a wildcard inserted, right? If that is the case, we can only reach one number only with connection plar-opx?

148
Views
0
Helpful
4
Replies
CreatePlease to create content