Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO Not disconnecting

Is there any way to have my FXO port disconnect after a certain time limit?  I have calls staying up for over 1 hour and I want them to die after 30 minutes.  Can I do this with an FXO port?

Cheers!
Dave

7 REPLIES
New Member

Re: FXO Not disconnecting

Hi,

  It is a common problem with loop start signalling. Can you try to use ground start signaling rather than loop start signalling and see whether it help ?

thanks.

Silver

Re: FXO Not disconnecting

I'm not sure if this is what you are asking for - this applies to a situation where someone hangs up and

the FXO port does not disconnect - try the following commands -

voice-port x/x/x
supervisory disconnect dualtone mid-call
timeouts call-disconnect 1
timeouts wait-release 1

timing guard-out 500
shut

no shut

HTH,

Art

Green

Re: FXO Not disconnecting

Please also look at

document http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

Hope this helps

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

Re: FXO Not disconnecting

What I am trying to acomplish in this one is I want any call to drop after 30 minutes.  Basically I want a timer, that says after 30 minutes where someone is still chatting away or not, drop the call, close the FXO port.

Cheers!
Dave

Silver

Re: FXO Not disconnecting

This Service Parameter will do what you want - but it is global....

This parameter specifies the minutes that a call can remain active before Cisco CallManager clears it. A value of zero disables the timer.
This is a required field.
Default:  720
Minimum:  0
Maximum:  35791
Unit: min

New Member

Re: FXO Not disconnecting

Thanks for the comments, but what is the actual command?

Also I am not using a Call Manager here, so not sure if it will apply.

Cheers!
Dave

Silver

Re: FXO Not disconnecting

Sorry, that is a CCM service parameter.  I know of no IOS command that will disconnect

an FXO port after a certain call duration.

Anyone else?

Good Luck!

Art

560
Views
0
Helpful
7
Replies
CreatePlease to create content