I am trying to configure a line connected to my FXO port to only do outbound calls. The line works just fine and I am able to make calls outbound, but when the line recieves a call the FXO port picks up and creates a busy signal situation for whoever tries to call in. The FXO port has an option for direction and I have set mine to outbound only, but do I need to enter any other syntax on the voice port so that it does not react to incoming calls?
With h323 / sip I would configure connection plar opx to a number that doesn't exist, so the line would never answer. The moment I want to give an answer, I could route the call to an error message. But the best thing to have outbound-only lines is to ask telco, in many countries they can set and bill this way.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4