FXO port config issues

[arumugasamy]

Dear Pros,

can you check this? I can see the FXO card through the sh ver but I cannot get to the port to configure it. This is mostly an IOS issue, but I want to make sure of it because the IOS is 4.0 enterprise, which I though support voice and this router is so critical which I don't want to take the chance to miss with it.

Sh Ver

Cisco 2821 (revision 53.51) with 1036288K/12288K bytes of memory.

2 Gigabit Ethernet interfaces

2 Serial(sync/async) interfaces

1 Virtual Private Network (VPN) Module

4 Voice FXO interfaces

R100-International(config)#dial-peer voice 7 pots

R100-International(config-dial-peer)#des

R100-International(config-dial-peer)#dest

R100-International(config-dial-peer)#destination-p

R100-International(config-dial-peer)#destination-pattern 3....

R100-International(config-dial-peer)#dir

R100-International(config-dial-peer)#direct-inward-dial

R100-International(config-dial-peer)#port ?

% Unrecognized command

R100-International(config-dial-peer)#port

Thanks

swami

[paolo bevilacqua]

Hi, most likely you do not have the necessary DSP modules in the router, do "show diag" to know. You should see PVDM2-xx without it you canno have the voice port to work.

Hope this helps, please rate post if it does!

[arumugasamy]

Dear,

My customer looking for the supporting documents.Where can we find it?

Swami

[paolo bevilacqua]

http://cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd80169812_ps5855_Products_Data_Sheet.html