Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXO port keeps line up.

Hello

We have a router that has 4 FXO ports connected to phone lines, but if the phone at the other end is off-line we get the message "The subscriber cannot be reached..." but the call is not disconnected.

Is there a way to disconnect calls that are not on-line.

Thanks

  • IP Telephony
6 REPLIES
Hall of Fame Super Gold

Re: FXO port keeps line up.

Do you receive tones after the announcement? If not, it's impossible to disconnect the call.

New Member

Re: FXO port keeps line up.

Not on this type of call.

What would be our options if we go an engaged tone?

Thanks

Hall of Fame Super Gold

Re: FXO port keeps line up.

To configure tone based disconnect supervision.

New Member

Re: FXO port keeps line up.

I've tried a number of various variations of the supervisory disconnect command I still doesn't disconnect call when I receive a busy tone.

Any thoughts.

Hall of Fame Super Gold

Re: FXO port keeps line up.

You do not have the tones configured correctly.

Bronze

Re: FXO port keeps line up.

Hi,

Please refer the following link.

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t2/feature/guide/ft_ansds.html#wp145069

The command "supervisory disconnect anytone" should work.

Regards...

-Ashok.

With best regards... Ashok ----------- Pls kindly rate if helpful or answered your question.
178
Views
0
Helpful
6
Replies
This widget could not be displayed.