We have a SIP trunk to a carrier. Yesterday, users were on the phone and experienced one-way out audio. This is related to the rxload being 255/255. We have 8 FXO ports for rollover. Is there a way to have the calls rollover to the FXO lines based on the rxload of the circuit?
On the Gateway, there is. Not sure on CCM. What is your architecture, which protocol are you using to the GW ? you would need to trunk SIP to the GW and it can reroute calls depending on status of jitter probes, pings, etc.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.