Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO port rollover?

I have a 2811 router with CME 4.2 loaded, using 4 port FXO card. I started with just one analog phone line for the office, but now have an additional one. How can I get incoming and outgoing calls to move to which ever line is available?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: FXO port rollover?

Hi, use trunk groups.

voice-port x/y/z

trunk-group pots

connection plar XXX opx

dial-peer voice 100 pots

trunkgroup pots

Then you can do certain settings (translations, hunt scheme) under "trunk group pots".

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Gold

Re: FXO port rollover?

Hi, use trunk groups.

voice-port x/y/z

trunk-group pots

connection plar XXX opx

dial-peer voice 100 pots

trunkgroup pots

Then you can do certain settings (translations, hunt scheme) under "trunk group pots".

Hope this helps, please rate post if it does!

New Member

Re: FXO port rollover?

For the incoming calls to rollover, you will have to have the phone company setup a hunt group on the POTS lines.

186
Views
0
Helpful
2
Replies