Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

fxo port seems busy even if the call is disconnected.

The FXO port in my UC520 will be busy all the time even if the call is disconnected. and I have to unplug and plug it again to make a call again.

kindly heip me with a solution.

2 REPLIES
New Member

Re: fxo port seems busy even if the call is disconnected.

Hi,

This is a very common issue with FXO ports. You should start with the following document to understand the problem and get some directions on solving it

http://www.cisco.com/en/US/customer/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

Cisco Employee

Re: fxo port seems busy even if the call is disconnected.

Where are you located?

Power denial and battery reversal are enabled by default on the circuit.  If the provider uses either of these (most NAM providers do), the port should disconnect.

Outside of the US, a disconnect tone is more common.  You should find out how your provider sends disconnects, but try configuring:

voice-port x/x

supervisory disconnect dualtone mid-call

timeouts call-disconnect 5
timeouts wait-release 5

317
Views
0
Helpful
2
Replies
CreatePlease to create content