We have a 2801 router with CME 8.1 and CUE 3.2.3. We receive calls on 3 analog lines into a 4 port FXO card. When calls arrive they reach an Automated Attendant which routes the calls properly. The issue we encounter is that the analog lines do not disconnect the calls quickly once the caller disconnects. It takes approximately 140 seconds before the calls disconnect. We have the following configuration on our FXO cards for each line.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.