Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FXO rotary configuration

Hi,

I am working with 8 analogues lines for a UCME / H323 gateway (Cisco 2811). I know the Telco can configure the 8 lines in a rotary upon request but in the event that they are not. Are there any configurations on the voice ports for especially for outbound calls.

Kind regards,

Richard.

2 REPLIES
Cisco Employee

Re: FXO rotary configuration

Use the preference command under the POTS dial peers to set up a order of outbound hunting. Preference 0 is the default, so it does not show in the config, so leave it off your first dial peer, then add preference 1-9 for the other dial peers.

Hall of Fame Super Gold

Re: FXO rotary configuration

voice-port x/y/z

trunk-group pots

dial-peer voice 9 pots

destination-pattern 9T

trunkgroup pots

This allows you to configure a single DP to control all lines. You can also set other properties under "trunk group pots"

Hope this helps, please rate post if it does!

154
Views
10
Helpful
2
Replies
CreatePlease to create content