I configured a FXO trunk port to a Valcom 9964 feedback eliminator. When I dial the route pattern associated with the FXO port on the Gateway there is about a second delay then I recieve a fast busy tone. If I sh call active voice compact I see the following...
462 ORG T22 g711ulaw VOIP P 10.82.4.95:21720
461 ORG T22 g711ulaw TELE P
464 ORG T0 g711ulaw VOIP P 0.0.0.0:0
463 ORG T0 None TELE P
The 0.0.0.0:0 call is the FXO. If I watch that port it just blinks green for a split second then turns off.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.