Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

FXO Voice ports remains off-hook after conference CME 7.1

Hi,

I have an issue that is really a headache for end users. I have CME 7.1 con 4 FXO ports.

when any user set a conference (3 parties, 1 internal and 2 PSTN phone numbers), after finishing the conference the fxo ports remains off-hook.

If I type "sh voice call status" the information shown the phone numbers dialed (PSTN phones)  for the previous conference even though the conference has been finished.

also, if I type " sh voice port summary" I see the fxo ports in use but I know there is no calls stablished.

CME info

Version 12.4(24)T3

System image file is "flash:c2801-spservicesk9-mz.124-24.T3.bin"

Cisco 2801 (revision 6.0) with 238592K/23552K bytes of memory.
Processor board ID FTX1046W2HK
2 FastEthernet interfaces
4 Voice FXO interfaces
1 DSP, 8 Voice resources
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

any idea about this issue?

regards

1 REPLY
Hall of Fame Super Gold

Re: FXO Voice ports remains off-hook after conference CME 7.1

381
Views
0
Helpful
1
Replies
CreatePlease to create content