Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXO with pulse dialling

In Kiev, Ukraine.

I have 4 analogue lines connected on a 4 port FXO card. When connected to the Siemens PABX, all lines can call anywhere. When I connect the lines one by one to the same port on the gateway with the same configuration, I have only 1 line being able to make only local calls. I plug those lines 1 by one on an analog phone, with the setting to pulse, then all of them can also call anywhere. It does not make sense that I use the same port for testing via the CCM, and only 1 can dial and only local.

Any advice.

1 REPLY
Cisco Employee

Re: FXO with pulse dialling

Can you get these debugs for a failure, so we can physically see why the second call fails?

debug voip ccpai inout

debug vpm sig

Also include:

sh run

sh voice call sum

210
Views
0
Helpful
1
Replies