I have 1760 router installed with c1700-ipvoicek9-mz.124.15-T7.bin IOS installed also with CME 4.1, but I have a problem, I inserted 1 FXS card and 1 FXO card on the slot, but when I connect my analog my phone to the fxs ports, the analog phones has no dial tone. is thier any configuration i need to do? below also is the output of the sh voice dsp?
Can someone advice?
o sh voice dsp
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...