Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXS and FXO ports not showing

Hey all. I hope this is a simple one:

A 2801 shows this inventory:

Installed image archive

Cisco 2801 (revision 6.0) with 179200K/17408K bytes of memory.

Processor board ID FHK1044F2QH

2 FastEthernet interfaces

1 ATM interface

1 Virtual Private Network (VPN) Module

1 DSP, 8 Voice resources

1 802.11 Radio

IOS: Version 12.4(15)T1, ADVENTERPRISEK9-M

The 2 new installed cards: 2fxs and 2fxo in slot 0 and 2 are not being recognized.

The PVDM is seen as PVDM2-8 successfully.

After trying a few IOSs i gave up. Any idea what IOS will recognize the VICs?

Many thanks.

  • IP Telephony
1 REPLY
New Member

Re: FXS and FXO ports not showing

Turned out to be Vic-2fxo and Vic-2fxs cards not Vic2-2fxo and Vic2-fxs like requiered.

2800 series requieres VIC2 cards.

198
Views
0
Helpful
1
Replies