Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXS connect to modem

Does anyone using FXS to connect modem for dial-up purpose? Is it ok?

4 REPLIES
Hall of Fame Super Gold

Re: FXS connect to modem

Hi,

supporting modem in VoIP is possible, but will require a lot of attention in configuration and is subject to limitations. Basically, there are two options, modem pass-through and modem relay.

What is the complete picture? Do you use CCM? What is the other end of the call ?

New Member

Re: FXS connect to modem

we're using CCM 4.1(3)sr3a with FXS of voice gateway C2851 12.4(3b). the modem is mainly for dial-out only with 56kpbs. the far-end is also a modem.

New Member

Re: FXS connect to modem

We're also using CCM with a C2821 voice gateway. I have modem calls originating on a PRI and I'd like them to terminate on an FXS port.

Hall of Fame Super Gold

Re: FXS connect to modem

Hello,

please see the following document for configuring modem relay with CCM:

http://cisco.com/en/US/products/ps6441/products_feature_guide09186a00805138e7.html

Hope this helps,please rate post if it does!

240
Views
0
Helpful
4
Replies
CreatePlease to create content