Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXS DID Card Config

If someone could confim that my configuration it would be much appriciated. We are cancelling our PRI at a location because it is no longer needed, and moving to a 4 line Analog DID trunk group with incoming abilities only. The significant digits coming from the carrier should be 4, and we are going to add a 7 to each of the numbers in order to sent the call to the employee's extension.

trunk group AnalogDID

voice translation-rule 3

rule 1 /^\(....\)/ /7\1/

voice translation-profile InboundDID

translate called 3

voice-port 2/0/0

trunk-group AnalogDID

signal did wink-start

!

voice-port 2/0/1

trunk-group AnalogDID

signal did wink-start

!

voice-port 2/0/2

trunk-group AnalogDID

signal did wink-start

!

voice-port 2/0/3

trunk-group AnalogDID

signal did wink-start

dial-peer voice 150 pots

trunkgroup analogdid

description inbound Calling

translation-profile incoming InboundDID

preference 1

service default

incoming called-number 989757

direct-inward-dial

Will this work when I try to impement it? I am working with a 2821 and a VIC-4FXS/DID.

2 REPLIES
New Member

Re: FXS DID Card Config

Did you ever get inbound analog DID working? I have a similar scenario and am having issues.

Cisco Employee

Re: FXS DID Card Config

Don't put 'direct-inward-dial' on dial-peer 150. Because these are analogue ports this is not needed.

DID trunks are polarity sensitive as well (they rely on battery reversal to indicate wink, answer and disconnect), so you need to connect tip-tip/ring-ring correctly as well.

994
Views
0
Helpful
2
Replies