We have a VIC-4Fxs/DID card inserted into a NM-HD-2V module in a 3725 router
The first two ports on the card work find but ports 3 and 4 never go off-hook. When a call comes in i see the port ringing but when i pick up the phone i hear clicks and when i hang up the phone it starts rining again.
When i try to initiate a call i get no dial tone i even tried setting for connection plar and still do not see the phone go off-hook. I verified that the port is set for loop-start signaling...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...