Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXS remains ringing many seconds

Hi,

When a call is set from PSTN and nobody answer on phone connected to FXS port  if the  calling party off hooks the phone the  phone connected on FXS port remains more than 40 seconds ringing.

I have checked several post about this but no success up to now.

for the moment I tried the following option

voice-port 0/3/1
disconnect-ack
cptone MX
timeouts call-disconnect 0
timeouts wait-release 1
description FAX 1190

any config that have been confirmed it works fine?

regards

3 REPLIES
Hall of Fame Super Gold

Re: FXS remains ringing many seconds

Prom PSTN how ? FXO? PRI? E1 R2?

New Member

Re: FXS remains ringing many seconds

Hi,

From PSTN by means of E1 R2 telmex

this is my config of E1

network-clock-participate wic 0
!
controller E1 0/0/0
framing NO-CRC4
ds0-group 1 timeslots 1-15 type r2-digital r2-compelled ani
cas-custom 1
  country telmex
  category 2
  answer-signal group-b 1
  caller-digits 4

regards

Hall of Fame Super Gold

Re: FXS remains ringing many seconds

Check with "debug vpm signal" that when the calling party hangs up, the router is made aware and can tear down the call to FXS.

167
Views
0
Helpful
3
Replies