Here is the deal: I have two routers 2800 which are connected with ISDN PRI. The First router is under my administration and in this case it acts as providers router. The other router on other side of PRI is business customer's router which has CME installed and one FXS port with fax attached to it. The outbound fax can be sent and this part works well. The problem is with receiving fax which doesn't work. (The call is immediatelly released). Other strange thing I noticed is if I retry the inbound call immediatelly after the first attempt was rejected, I get the fax signal (which was't the case the first time)!! Please help me with any suggestions. Is it problem of my router (provider) or customer's (CME)?
you might have overlapping DPs. Do "show dialplan number XXX" with the fax number and if you see more than one entry, that is the problem. Also, you have not explained how the fax is attached on your side.
So here is only customer's fax relevant (which is attached to CME by FXS port). This fax can make outbound faxes (FXS->CME->PRI->Provider router->Softswitch....)but the other way doesnt work. When I call this fax machine first time I am immediatelly disconnected and on the next try (the one that is immediatelly after) I get the fax signal. Problem is also that I dont have access to customers CME. I am only interested if everything is fine with the provider's router. I am also sending my dial peers. In this case for inbound faxes I am using 3000 and 4000:
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...