I have the following scenario. CCM with version 4.2(1) working with 200 IP phones and VG (H.323) to connect to the PSTN cloud.
The VG has got the 4 port FXS card also, so we want to connect the analog extensions through the fxs ports and manage. So can we register these analog extensions on the call manager and be able to manage the call admission control like we do with the ip phones.
If not how can we manage the call admission control in the vg only for the extesions connected through the fxs ports (what I mean manage call admission control is like allow/restrict extensions to place calls outside etc.,)
What kind of a VG do you have ?? If it is a Cisco Router, then u can register it as an MGCP Gateway and assign extensions to it. Once that is done, it can be used just like a Phone. if it is a VG248 or VG224, then u can even use SCCP
You can use the same router for H.323 and MGCP without any issue as long as it is not the same interface. So, I believe you are using FXO/PRI for PSTN calls. If this is rt, you can register the FXS as MGCP Endpoints
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...