Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

G722 Codec

Hi

we just received 5 new 8945 phones and I want to use the G722 codec on them, the question is where can I get this from or does it come installed with CM already. And if it's already on CM where do I go to check and make it the default.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

G722 Codec

You set wheter to advertise/use it at the service parameter level and device level.

This parameter determines whether Cisco Unified Communications  Manager allows G.722 negotiation for all, some, or no devices. Valid  values specify Enabled for All Devices, Enabled for All Devices Except  Recording-Enabled Devices, or Disabled.
   This is a required field.
   Default:                  Enabled for All Devices

On device:

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

G722 Codec

You set wheter to advertise/use it at the service parameter level and device level.

This parameter determines whether Cisco Unified Communications  Manager allows G.722 negotiation for all, some, or no devices. Valid  values specify Enabled for All Devices, Enabled for All Devices Except  Recording-Enabled Devices, or Disabled.
   This is a required field.
   Default:                  Enabled for All Devices

On device:

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
358
Views
0
Helpful
1
Replies