Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Gatekeeper Alias Static Command with Priority

I am using Gatekeeper to control calls between a CallManager cluster and CME. When using the alias static command in gatekeeper, calls to CCM phones load balance between the Sub and the Pub. I cannot find a way to implement a priority as you can with the zone prefix command. Anyone know how to implement priorities on the alias static command?

Thanks!!!

Adam

2 REPLIES
Bronze

Re: Gatekeeper Alias Static Command with Priority

No, you cannot set priorities in the alias static command. For more information kindly refer the following url,

http:/www./cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080a52.html#wp1043867

New Member

Re: Gatekeeper Alias Static Command with Priority

Thanks for the response. I was thinking there was not a way, but needed to ask.

So now let's approach this scenario from the other side. The Gk has an alias static from a remote H323 device (CME in the case). Since you cannot register CME to the Gk because he has an alias static, how do you get calls from CME into the GK destined for other sites?

Thanks!!!

Adam

150
Views
0
Helpful
2
Replies