I have a network with at least 20 GK registered to two DGK. In each GK are register 15-20 GW equipped with FXS card, connected to the local PBX. In this way I can use all phone connected to these PBX and with 4 to 8 lines I can redirect traffic trough the wan. On each GK are registered all the dial-peer assigned to those FXS port.
But the FXO interfaces are not registered; for this reason I can’t not reach these dial-peers remotely. I found that just de FXS interface is capable of register with the GK. What I need is some idea of how can I do reachable from different zones the dial-peers configured to user the port of the FXO card. Any help is appreciated.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.