the problem is u cant get CME to work as gateway and gatekeeper at the same time
the gateway-A need to rigister with the GK and have a dial-peer with distination as RAS the same on B
also it need a source interface as gateway side to work with gatekeer
Gatekeepers are H.323 devices that use the RAS protocol to communicate with Cisco voice gateways. RAS is a subset of the H.225 signaling protocol
also u need this stage to happen
Unicast discovery This method requires that the IP address of the gatekeeper is configured in the gateway. The gateway immediately sends a GRQ using User Datagram Protocol (UDP) port 1718. The gatekeeper either responds with a GCF or a GRJ
with ur config will not happns !!
the only way to get it work add additional device to work as GK and make those two CMEs register with it
I would imagine you can do CME/GK co-res.. I can tell you that I do IP2IP GW/GK just fine... however it definatly has lots of quirks because you must use via zones on your GK! Please paste the config...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.