Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

gatekeeper tech prefix

hi,

i have a gatekepeer with a callmanger and cme registered to it with the same tech prefix 1# and all in same zone, i have added zone prefix on the gk

my question is do i have to send 1# or 1#and the zone perfix or just the zone prefix in the calls between cm and cme

1 REPLY
Green

Re: gatekeeper tech prefix

That depends what exactly you want to do,

since u have only 1 zone and 1 tech prefix, when GK is doing the call routing will ignore tech prefix, but GW do still send it, so make sure u strip it.

ie CME 1#

CCM-Trunk 1#

if you use only 1 zone, make sure u configure zone prefix properly.

zone prefix gk 2...

zone prefix gk 3...

since you are using only one zone, make sure u specify correctly to which gw u send the call (tip use gw-default priority) command

151
Views
0
Helpful
1
Replies