I am not sure what I am missing but I am unable to complete a call between two local zones on a single gatekeeper setup. I have an endpoint registering in one zone and trying to complete a call to a gateway in another zone.
If I remove the second zone and put both the endpoint and the gateway in the same zone it works fine.
here is the current gatekeeper config:
zone local ep dom.com 10.1.79.77
zone local ucm dom.com
zone prefix ucm 5....
gw-type-prefix 1#* default-technology
The gateway is an h.225 trunk to call manager 4.2.3 and the endpoint is a Tandberg conference phone.
The debug message is a seeing is:
value RasMessage ::= admissionReject :
rejectReason calledPartyNotRegistered : NULL
nonStandardIdentifier h221NonStandard :
Any clue as to what I am missing would be a tremendous help.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...